Shortened double-walled carbon nanotubes by high-energy ball milling
by S.K. Smart, W.C. Ren, H.M. Cheng, G.Q. Lu, D.J. Martin
International Journal of Nanotechnology (IJNT), Vol. 4, No. 5, 2007

Abstract: Despite significant scientific interest, there are currently no widely accepted methods for the production or shortening of CNT that offer fine control over CNT length distribution. This paper reports the production of shortened double walled carbon nanotubes (DWNT) by high-energy ball milling and their characterisation via TEM, SEM, Raman, TGA and XPS techniques. Image analysis showed that ball milling was effective at shortening DWNT; however, fine control of the tube length distribution was not possible. The high-energy milling was found to lead to DWNT destruction if samples were processed for longer than 4 min. Ball milling was also found to qualitatively increase amorphous carbon content. A slight increase in side wall oxidation with increased ball milling time was observed via XPS. These well characterised DWNT samples will be employed in polymer nanocomposite and CNT toxicology studies.

Online publication date: Mon, 06-Aug-2007

The full text of this article is only available to individual subscribers or to users at subscribing institutions.

 
Existing subscribers:
Go to Inderscience Online Journals to access the Full Text of this article.

Pay per view:
If you are not a subscriber and you just want to read the full contents of this article, buy online access here.

Complimentary Subscribers, Editors or Members of the Editorial Board of the International Journal of Nanotechnology (IJNT):
Login with your Inderscience username and password:

Username:        Password:          Forgotten your password?

Want to subscribe?
A subscription gives you complete access to all articles in the current issue, as well as to all articles in the previous three years (where applicable). See our Orders page to subscribe.

If you still need assistance, please email subs@inderscience.com